Material Safety Data Sheet
OVEN LUBE 20
Material Identification and Use
| Manufacturer's Name | NOCO Energy Corp. |
| Manufacturer's Address | 2440 Sheridan Dr., Tonawanda, NY 14150 |
| Emergency Phone Number | 1-800-424-9300 (Chemtrec) |
| Supplier's Address | P.O. Box 86, Tonawanda, NY 14151 |
| Supplier Emergency Phone Number | 1-800-500-6626 |
| Product Name | Oven Lube 20 |
| Product Code | NOC7472 |
| Chemical Name and Synonym | Petroleum Hydrocarbon plus Additives |
| Product Use | Oven Chain Lubricant |
Ingredients
| Components | Percentage | CAS Number | Hazard Data |
| Stoddard Solvent | 55 - 65 | 8052-41-3 | OSHA TWA 100 PPM (300mg/m3)
ACGIH TWA 100 PPM (300mg/m3) |
| Interchangeable Base Oils | 0 - 30 | 64741-88-4
72623-86-0 64742-65-0 |
OSHA PEL/TWA 5mg/m3 (mist)
ACGIH TLV/TWA 5mg/m3 (mist) ACGIH STEL/TWA 10mg/m3 (mist) |
| Proprietary Mixture | 1 - 2 | Proprietary | OSHA PEL/TWA 5mg/m3 (mist)
ACGIH TLV/TWA 5mg/m3 (mist) ACGIH STEL/TWA 10mg/m3 (mist) |
| Molybdenum Disulfide | 1.5 - 2.5 | 1317-33-5 | OSHA PEL/TWA 5mg/m3 (mist)
ACGIH TLV/TWA 5mg/m3 (mist) ACGIH STEL/TWA 10mg/m3 (mist) |
| Methyl Ester | 7 - 8 | N/A | None |
| WHMIS Classification | B3 |
Physical Data
| Physical State | Liquid |
| Odour and Appearance | Grayish Black, Solvent Odor |
| Specific Gravity | 0.867 |
| Vapor Pressure (MM HG @ 20° C) | 5 |
| Vapour Density | 3.0 |
| Evaporation Rate | > 40X Slower |
| Boiling Point | > 320 - 390°F (170 - 199°C) |
| Freezing Point | Not Determined |
| pH | N/A |
| Solubility in H20 | NIL (% by volume) |
Fire and Explosion Hazards
| Conditions of Flammability | Addition of water or foam may cause frothing. Do not cut, drill or weld empty containers. |
| Extinguishing Media | Water Spray, Regular Foam, Dry Chemical or Carbon Dioxide. |
| Flashpoint and Method of Determination | 105°F min. TCC (40.5°C min.) |
| Flammable Limits in Air % B. V. Upper | Estimated 4.0% Volume |
| Flammable Limits in Air % B. V. Lower | Estimated 0.6% Volume |
| NFPA - Hazard Class | Health:2 Fire:2 Reactivity:0 |
| Hazardous Combustion Products | Oxides of Carbon, Sulfur, and Nitrogen |
| Unusual Fire an Explosion Hazard | Danger! Combustible liquid and vapor. May cause skin irritation. Pulmonary aspiration hazard can enter lungs and cause damage. Do not cut, weld, pressurize, braze, solder, drill, grind, or expose to heat, flame, sparks, static electricity or other sources of ignition. This may cause injury or death. |
| Special Fire Fighting Procedures | Cool tank/container. Wear self-contained breathing apparatus. Wear structural firefighters protective clothing. |
Reactivity Data
| Chemical Stability | Stable |
| Incompatible Materials | Strong oxidizing agents: Peroxides, Chlorine, Strong Acids, etc. |
| Hazardous Decomposition | Oxides of Carbon, Sulfur, and Nitrogen |
| Hazardous Polymerization | Material is not known to polymerize. |
Health Hazard Information
| Routes of Entry | |
| Skin Contact | Practically non-toxic if absorbed. Moderate irritation removes natural oils and fats from skin with prolonged or repeated contact. |
| Eye | Contact with the eye may cause minimal irritation. |
| Inhalation | Excessive exposures may cause irritation to eyes, nose, throat, and respiratory tract irritation, central nervous system effects, dizziness, loss of balance and coordination, unconsciousness, coma, respiratory failure and death. |
| Ingestion | Harmful or fatal if swallowed. Pulmonary aspiration hazard if swallowed and vomiting occurs - Can enter lungs and cause damage. |
| Carcinogenicity | Not listed as a carcinogenic. |
Emergency and First Aid Procedures
| Eyes | Flush with water for at least 15 minutes. If irritation persists, obtain medical assistance. |
| Skin | Wash with soap and water until no odor remains. If redness or swelling develops, obtain medical assistance. Wash clothing before reuse. |
| Inhalation | Move person to fresh air. If not breathing, give artificial respiration, obtain medical assistance. |
| Ingestion | Do not induce vomiting! Do not give liquids. Obtain emergency medical attention. Small amounts which accidentally enter mouth should be rinsed out until the taste is gone. |
Preventative Measures
| Ventilation Requirements | Use only with adequate ventilation. Ventilate as needed to comply with exposure limit. |
| Respiratory Protection | Concentration is air determines protection needed. Use only NIOSH certified respiratory protection. Half mask air purifying respirator with organic vapor cartridges is acceptable to 10 times the the exposure limit. |
| Eye Protection | Splash proof chemical goggles or full face shield recommended to protect against splash of product. |
| Protective Gloves | Protective gloves recommended when prolonged skin contact cannot be avoided. The following glove materials are acceptable; polyethylene, neoprene, nitrile, polyvinyl alcohol, viton. |
| Personal Hygiene | Wash hands thoroughly after handling. |
| Note | N/A |
Environmental Procedures
| Spills or Releases | Prevent ignition! Stop leak. Ventilate area. Contain spill. Wear respiratory protection for large spills, leak or release. use personal protective equipment. Absorb on inert material. Shovel, sweep or vacuum spill. |
| Disposal | Follow federal, state, and local regulations. RCRA hazardous waste. Do not flush to drain/storm sewer. Contract to authorized disposal service. |
| Storage | Keep away from heat. Sparks and flame. Keep container tightly closed. |
Regulatory Information
| Dept. of Transportation | DOT Shipping Name: Petroleum distillates, NOS, Combustible Liquid, UN1268, III |
| TSCA | This product or all components of this product are listed on the US TSCA Inventory. |
| CERCLA | If this product is accidentally spilled, it is not subject to any special reporting under the contact local authorities to determine if there may be other local reporting requirements. |
| RCRA | No Data |
| SARA Title III - Section 302 | N/A |
| Section 311/312 | Immediate and Fire Hazard |
| Section 313 | Not Applicable |
Preparation Date of Material Safety Data Sheet
| Prepared By | NOCO - Tom Scoda |
| Phone number of Preparer | 1-800-500-6626 |
| Date Prepared | 07/17/2000 |
| Revised Date | 06/01/2008 |
Disclaimer
| Information presented herein has been compiled from information provided to us by our suppliers and other sources considered to be dependable and is accurate and reliable to the best of our knowledge. Nothing herein is to be construed as recommending any practice or the use of any product in violation of any patent or in violation of any law or regulation. It is the users' responsibility to determine the suitability of any material for a specific purpose and to adopt such safety precautions as may be necessary. We make no warranty as to the results to be obtained in using any material and since conditions of use are not under our control, we must necessarily disclaim all liability with respect to the use of any material supplied by us. |